Enerpac SBL1100, Instruction And Maintenance Manual

Page: 96 / 151

Document number: ED. 03622.00.001.R04.ENG
Page 96 of 151
ED.02518.00.001.R08.ENG
Page 96
To tilt a load, proceed as follows.
In the procedure below, the controls of the RCC are indicated like
“ [x] ”.
For the layout of those controls see page 81.
1.
Apply the RCC
2. Record all activities during the operation using the form given in Appendix D “ Recording a
lifting operation ”.
3. Verify that all checklists have been completed and signed off:
x
Appendix A “ Checklist for planning a lifting operation ”
x
Appendix B “ Checklist for installing the System ”
x
Appendix C ” Final checks ” .
4. Select the two ‘passive’ units on the RCC
5. Manoeuvre the header beam of the units attached to the (future) bottom of the load right
above the load.
6. Attach the bottom of the load to the header beam.
7. De-select the passive units on the RCC
8. Select the two ‘active’ units on the RCC
9. Manoeuvre the header beam of the active units right upon the (future) top of the load.
10. Attach the header beam to the load.
11. Extend the cylinder for 5 cm.
12. Let the units travel towards the passive units in such a way that the lifting eyes of the load
are once again directly underneath the header beam.
13. Verify that the lifting eyes are straight underneath the header beam with in tolerance
of 0.2°. Use a plumb line, a laser or a theodolite.
14. Repeat the steps 8 .. 10 until the load has been tilted completely.