Enerpac SBL1100, Instruction And Maintenance Manual

Page: 85 / 151

Document number: ED. 03622.00.001.R04.ENG
Page 85 of 151
ED.02518.00.001.R08.ENG
Page 85
6.3.3. Calibrate the stroke sensor
This paragraph describes how to calibrate the stroke sensor, which measures the height of the
boom.
Reference is made to the layout of the remote control console on page 82.
)
Calibration has to be performed when stroke sensors were changed, so calibration
is
not part of the daily routine.
Proceed as follows:
1. Preconditions:
x
RCC switched off
x
Units switched off.
2. Set “Speed” on the RCC to the ‘hare’ (high speed)
3. P ress “Zero lift” and keep it pressed while you
switch the console on.
Keep “Zero lift” pressed until the message “ System
not ready” is shown
4. Release the “Zero lift” button.
The RCC is now in calibration mode.
The
“Calibration mode” message appears on the
display.
5. Switch the unit which you want to calibrate on and
start its motor.
6. Select the unit on the RCC
7. Retract the cylinders to the very minimum position