Enerpac SBL1100, Instruction And Maintenance Manual

Page: 114 / 151

Document number: ED. 03622.00.001.R04.ENG
Page 114 of 151
ED.02518.00.001.R08.ENG
Page 114
1.5. Oil
Take an oil sample to analyze EE
x Change oil if
necessary
Replace the hydraulic oil.
See section 10.2.1 “ Drain the oil ” and
Section 10.2.2 “ Filling the tank ”
EE
x Or after 2000
running hours
Check the oil level O x
1.6. Hydraulic filter
Check and replace the filter element.
See section 10.2.3 “ Replace the filter
element
”.
EE
x x And if
indicated by
the clogging
indicator
Replace the seals of the filter housing EE x
1.7. Breathers Replace the breather EE x
1.8. Bellhousing Check on damages O x
Check if the bolts are still tightened O x x
Replace motor pump coupling EE x
1.9. Cooler Check on oil leakage and damages O x
Check if the bolts are still tightened O x x
Clean the cooler O x
Measure pressure difference “delta p” at the cooler EE x
2. Hydraulic connections
2.1. Pipes, hoses and
brackets
Check on oil leakage and damages O x
Check if the couplings are tightened well. O x x
Replace all seals within the piping (Waldform) EE x
Replace all hoses EE x
Replace all plastic brackets
EE x
2.2. Couplings and
quick-screw
couplings
Check on oil leakage and damages O x
Check if the couplings are tightened well. O x x
Replace all seals of the couplings EE x
Replace fast couplings and screw couplings EE x
2.3. Gauges,
measurement
sensors
Check on damages O
x
Check the tightening bolts, nuts and components O
x x
Replace all seals EE
x
Replace all gauges EE
x