Enerpac SBL1100, Instruction And Maintenance Manual

Page: 12 / 151

Document number: ED. 03622.00.001.R04.ENG
Page 12 of 151
ED.02518.00.001.R08.ENG
Page 12
o) knowing and following the procedures specified by the system manufacturer or
approved by a qualified person for assembly, disassembly, and setting up the system.
p) knowing how to travel the system, if applicable.
q) ensuring that the load and rigging weight(s) have been provided.
r) calculating or determining the rated load for all configurations that will be used and
verifying, using the capacity chart(s), that the system has sufficient capacity for the
proposed operation.
s) considering all factors known that might affect the system capacity and informing the
system Director of the need to make appropriate adjustments.
t) knowing the standard and special signals as specified in the applicable chapter and
responding to such signals from the signalperson. When a signalperson is not required,
the system Operator is then responsible for the movement of the system. However, the
system Operator shall obey a stop signal at all times, no matter who gives it.
u) understanding bask load rigging procedures. For responsibility of rigging the load and
ensuring that the load is rigged properly
v) if power fails during the operations
x
set all locking devices
x
move all power controls to the OFF or neutral position
x
secure and stabilize the load, if practical
w) before leaving the system unattended
x
secure and stabilize the load
x
set all locking devices
x
put the system controls in the OFF or neutral position
x
turn off the system power source
x
follow the recommendations as given in this manual or given by a qualified
person for securing the system
1.8.6. Hand signals
The following hand signals are applicable when using the system:
RAISE.
With forearm
vertical, forefinger
pointing up, move
hand in small
horizontal circle.
LOWER.
With arm extended
downward, forefinger
pointing down, move
hand in small
horizontal circle.
GANTRY
TRAVEL.
Arm extended
forward, hand
open and slightly
raised, make
pushing motion in
direction of travel. SIDE SHIFT.
Palm up,
fingers closed, thumb
pointing in direction
of motion, jerk hand
horizontally.