Enerpac SBL1100, Instruction And Maintenance Manual

Page: 67 / 151

Document number: ED. 03622.00.001.R04.ENG
Page 67 of 151
ED.02518.00.001.R08.ENG
Page 67
5.7.2. Mount the header beam on top of the boom
To mount the header beams on top of the boom proceed as follows:
1. Remove the six bolts at the top of the swivel
plate
2. Remove the locking strips.
3. Put the header beam on top of the swivel.
4. Clamp the header beam to the swivel using
the distance strips and the locking strips.
Note that two types of beams can be mounted:
x
Wide (480 mm)
x
Narrow (300 mm)
Set the locking strips of the swivel according
to the applied type.
5. Level the beam. Use [1] of the control panel
(see page79).
6. Tighten the bolts according to the table in
Appendix 0 “
Torque
settings
”.
)
x
Make sure that all bolts are
tightened properly.
x
Always apply all bolts
bolts bolt
Locking strips
Swivel plate
Distance
strips
Narrow:
Wide: