EnergyLogic EL-140H, Installation & Operation Manual, Page: 8 / 96

1.2 General Warnings
•
The EnergyLogic burner is to be used only in the EnergyLogic furnace
provided. Do not attempt to use the burner for other purposes.
•
Do not tamper with the unit or controls – call your service technician.
•
Do not attempt to use unit with broken or damaged components.
•
If you are intending to use the furnace with existing building ductwork,
make sure that the requirements are met for allowable external static pressure (see
specification table in appendix).
•
Do not allow unqualified personnel to install or service the furnace,
electrical system, or flue system. Contact EnergyLogic for help with finding a qualified
installation and service company. Failure to install and maintain your heater properly will
void your warranty and the UL listings.
•
Do not attempt to start the burner when excess oil has accumulated,
when the furnace is full of vapor, or when the combustion chamber is very hot.
•
Do not start the burner unless all cleanout panels are secure in place.
•
KEEP THE FUEL VALVE NEAREST THE SUPPLY TANK SHUT OFF
WHEN THE BURNER IS SHUT OFF FOR EXTENDED PERIODS.
•
Turn off power to the burner when the burner is off for extended periods.
•
The furnace is designed to be installed above head height, or in a manner
that restricts access.
•
USED OILS CONTAIN HEAVY METALLIC COMPOUNDS AND
FOREIGN MATERIALS. WHEN BURNED, THESE COMPOUNDS ARE EMITTED
FROM OR DEPOSITED WITHIN THIS HEATING APPLIANCE AND THEREFORE
CARE SHOULD BE TAKEN WHEN USING, CLEANING AND MAINTAINING THIS
EQUIPMENT.
•
EnergyLogic recommends that the building have a secondary heat source
during times the furnace is down for maintenance or service. Used oil furnaces require
maintenance. Also, used oil may sometimes be unavailable or burn poorly due to
contaminates in the oil. The heat from the secondary heater should be directed away
from the furnace.
1.3 Safety Hazards
There are potential hazards associated with operation of this or any other furnace. In addition
to the codes and regulations listed in the following section, general safety rules and the
precautions should be followed at all times to prevent accidents that could lead to personal
injury, death or property damage. Only those qualified should perform the tasks. Specific
safety hazards include:
Electricity: The EnergyLogic furnace operates on 115V/60Hz electrical power.
Turn power off at the circuit breaker and lock it out prior to performing any work on the furnace
2
Call 1-615-471-5290 for Technical Support