Endress ESE 1104 DBG ES FS DIN, Operating Instructions Manual

Page: 42 / 88

42
ESE 904 - 1304 DBG DIN Status: at January 2013
4.8 Monitoring the operating condition using the multifunctional
display
The display will only be active once the engine has started.
All LEDs light up for about 2 seconds to allow checking as
soon as the START-STOP switch
is set to the position "Op-
erate“. The normal operational lighting is then shown after-
wards for about 30 seconds. If the engine is not started with-
in this period, the E-MCS 4.0 goes into energy saving mode
and the indicator goes dark. To bring the E-MCS 4.0 back
into a ready-to-operate condition again, the START-STOP
switch must first be turned into the position "STOP“. The
display intensity is dependent on the ambient brightness
(sensor see Figure 4-6-(5)).
Fig. 4-6: Multi-functional display
Displayed
(see Fig. 4-6-(1))
when the generator starts or is acti-
vated for 30 seconds when the START / STOP switch is
turned to the “Operate” position.
If the display is red
(see Fig. 4-6-(16))
whilst the generator is
running then the temperature is too high and the generator
must be switched off.
(Only active if the special “Warning signal II”, “Firecan” option is fitted!)
Started by hand:
Electrical start
Operating hours:
Ambient temperature: