Endress+Hauser Proline Promag W 500, Operating Instructions Manual

Page: 153 / 262

Proline Promag W 500 PROFINET Commissioning
Hauser 153
Current output 1 to n simulation →  154
Value current output 1 to n →  154
Frequency output simulation 1 to n →  154
Frequency value 1 to n
→  154
Pulse output simulation 1 to n →  154
Pulse value 1 to n →  154
Switch output simulation 1 to n
→  154
Switch status 1 to n →  154
Relay output 1 to n simulation →  154
Switch status 1 to n →  154
Device alarm simulation →  154
Diagnostic event category →  154
Diagnostic event simulation →  155
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
entry / User
interface
Factory setting
Assign simulation process variable – Select a process variable for
the simulation process that is
activated. • Off
• Volume flow
• Mass flow
• Corrected volume
flow
• Flow velocity
• Conductivity
*
Off
Process variable value A process variable is selected
in the
Assign simulation
process variable parameter
(→  153).
Enter the simulation value for
the selected process variable. Depends on the
process variable
selected 0
Status input simulation 1 to n – Switch simulation of the status
input on and off. • Off
• On Off
Input signal level 1 to n In the Status input simulation
parameter, the On option is
selected.
Select the signal level for the
simulation of the status input. • High
• Low High
Current input 1 to n simulation – Switch simulation of the
current input on and off. • Off
• On Off
Value current input 1 to n In the Current input 1 to n
simulation parameter, the On
option is selected.
Enter the current value for
simulation. 0 to 22.5 mA 0 mA