Endress+Hauser Proline Cubemass C 300, Operating Instructions Manual

Page: 159 / 216

Proline Cubemass C 300 Diagnostics and troubleshooting
Hauser 159
Diagnostic
number
Short text Remedy instructions Status
signal
[from the
factory]
Diagnostic
behavior
[from the
factory]
119 Sensor initialization
active Sensor initialization in progress, please
wait C Warning
140 Sensor signal
asymmetrical 1. If available: Check connection cable
between sensor and transmitter
2. Check or replace sensor electronic
module (ISEM)
3. Replace sensor
S Alarm
1)
141 Zero adjustment failed 1. Check process conditions
2. Repeat commissioning procedure
3. Check sensor F Alarm
142 Sensor index coil
asymmetry too high Check sensor S Warning
1)
144 Measurement error too
high 1. Check process conditions
2. Check or change sensor F Alarm
1)
Diagnostic of electronic
201 Electronics faulty 1. Restart device
2. Replace electronics F Alarm
242 Firmware incompatible 1. Check firmware version
2. Flash or replace electronic module F Alarm
252 Module incompatible 1. Check electronic modules
2. Check if correct modules are
available (e.g. NEx, Ex)
3. Replace electronic modules
F Alarm
262 Module connection
interrupted 1. Check or replace connection cable
between sensor electronic module
(ISEM) and main electronics
2. Check or replace ISEM or main
electronics
F Alarm
270 Main electronics
defective 1. Restart device
2. Replace main electronic module F Alarm
271 Main electronics faulty 1. Restart device
2. Replace main electronic module F Alarm
272 Main electronics faulty Restart device F Alarm
273 Main electronics
defective 1. Pay attention to display emergency
operation
2. Replace main electronics
F Alarm
275 I/O module defective Change I/O module F Alarm
276 I/O module faulty 1. Restart device
2. Change I/O module F Alarm
283 Memory content
inconsistent Restart device F Alarm
302 Device verification active Device verification active, please wait. C Warning
1)
303 I/O 1 to n configuration
changed 1. Apply I/O module configuration
(parameter 'Apply I/O configuration')
2. Afterwards reload device description
and check wiring
M Warning
304 Device verification failed 1. Check verification report
2. Repeat commissioning procedure
3. Check sensor
F Alarm
1)
311 Sensor electronics
(ISEM) faulty Maintenance required!
Do not reset device M Warning
330 Flash file invalid 1. Update firmware of device
2. Restart device M Warning