Endress+Hauser Proline Cubemass C 300, Operating Instructions Manual

Page: 113 / 216

Proline Cubemass C 300 Commissioning
Hauser 113
Parameter Description Selection / User interface Factory setting
Zero point measured Shows the zero point measured for the
adjustment. Signed floating-point number –
Zero point standard deviation Shows the standard deviation of the zero
point measured. Positive floating-point number –
Zero adjust
The zero point can be adjusted with the Zero adjustment wizard.
• A zero point verification should be performed before a zero adjustment.
• The zero point can also be adjusted manually: Expert → Sensor → Calibration
Navigation
"Setup" menu → Advanced setup → Sensor adjustment → Zero adjustment
‣
Zero adjustment
Process conditions →  114
Progress →  114
Status
→  114
Root cause →  114
Abort cause →  114
Root cause →  114
Reliability of measured zero point →  114
Additional information
→  114
Reliability of measured zero point →  114
Zero point measured →  114
Zero point standard deviation →  114
Select action →  114