Endress+Hauser Hart Proline Promag P 500, Operating Instructions Manual, Page: 114 / 210

Commissioning Proline Promag P 500 HART
114 Hauser
Parameter Prerequisite Description Selection / User
entry
Factory setting
Timeout The Burst network option or
the Master network option is
selected in the Capture mode
parameter.
Enter deadline for process
variable of external device.

If the waiting time is
exceeded, the diagnostic
message
F410 Data
transfer is displayed.
1 to 120 s 5 s
Failure mode In the Capture mode
parameter, the Burst network
option or Master network
option is selected.
Define behavior if external
process variable is missed. • Alarm
• Last valid value
• Defined value Alarm
Failure value The following conditions are
met:
• In the
Capture mode
parameter, the Burst
network option or Master
network option is selected.
• In the Failure mode
parameter, the Defined
value option is selected.
Enter value to be used by the
device if input value from
external device is missing. Signed floating-point
number 0
"Input" submenu
Navigation
"Expert" menu → Communication → HART input → Input
Parameter overview with brief description
Parameter Description User interface
Value Signed floating-point number
Status • Manual/Fixed
• Good
• Poor accuracy
• Bad
10.4.12 Configuring the relay output
The Relay output wizard guides the user systematically through all the parameters that
have to be set for configuring the relay output.
Navigation
"Setup" menu → Relay output 1 to n
‣
RelaisOutput 1 to n
Switch output function
→  115
Assign flow direction check →  115
Assign limit →  115
Assign diagnostic behavior
→  115
Assign status →  115