4 Wiring
ASP station 2000
68
EHauser
!
Note!
The terminal connection is in a protected position beneath the cabinet cover in the
electronics compartment. Therefore to connect the power supply, you must remove the
rear panel and the cover of the device before commissioning. To install the rear panel
and the cover, proceed in reverse order to the descriptions in the following two sections.
4.1.3
Mounting the cover
Fig. 7:
Mounting the cover
4.1.4
Mounting the rear panel
Fig. 8:
Mounting the rear panel
4.1.5
Terminal assignment
Fig. 9:
Position of the terminal board in the electronics compartment
1. Loosen the fixing
screws.
2. Lift the cabinet
cover at the front.
3. Pull the cabinet
cover forwards and
lift.
1. Loosen the fixing
screws.
2. Lift the rear panel up and remove it.
