EMTEK, LLC - R100 USERS MANUAL / AUG2019.REV01
47
To install a roll of printer paper/labels (see Fig 7.4.1):
1. View the printer from the front with printer labeling oriented normally for reading.
2. Pull up the handle in the top center of the “clear” paper cover until a click is heard, which releases the door
mechanism.
3. Lift the door up and back (remove the core from the previous roll if applicable).
4. Install the new paper, or label roll so the paper feeds from the bottom of the roll.
5. Hold the end of the label or paper roll forward while closing the printer door, until it clicks into place, locking
it shut.
6. Alignment for Paper or Label:
6a. If using black mark detection labels, position the middle of the black mark near the printers serrated
cutting edges on the printers door and case. You can manually pull the paper forward, or with the printer
turned on, hold down the power button to advance or feed the labels.
NOTE: Select and use the “LABEL” setting for “ROLL TYPE” in the R100 Printer Settings.
6b. If paper, or label stock without backing is used, no specific label alignment is required.
NOTE: Select and use the “PAPER” for “ROLL TYPE” in the R100 Printer Settings.
7.
Tear the excess paper, or label stock off the printer by pulling it forward against the printers serrated edge.
8.
The paper or label stock is loaded and the printer is ready for use.
Note:
If the paper does not feed out or no image appears on the paper after a print command has been sent, perform the
described steps, but check the orientation of the paper roll in the printer assembly. If the battery power is low, the
print output will be become very faint. Plug the printer into its power supply/charger if this occurs.
Fig 7.4.1 Loading Paper, or Label Roll in Thermal Printer
Step 1
Step 2
Step 3 Step 4
Step 5 Step 6 Step 7 Step 8
