EMTEK, LLC - R100 USERS MANUAL / AUG2019.REV01
22
Section 6
Quick Start Guide
If you are already familiar with the R100 Controller and RAS Sampler, and it is already set up at the desired
sampling location, follow these steps to get your controller running:
1.
If the R100 is plugged in to its’ power supply, press the ON/OFF power button on the right side of the unit
(Fig 4.3.1, #4). If not plugged in, plug the primary AC/DC power adapter cable into the power
receptacle on the right side of the R100, and then attach to an appropriate AC power supply source that is
100-240 VAC, and 50/60 Hz.
2.
Set the date/time if the R100 has been unplugged from DC power, as the date/time is not retained when
the unit does not have power supplied to it.
3.
Set other required sample run parameters using the touch screen interface. (See Section 7.1)
4.
If a label/paper output is desired, ensure that the OPTIONAL printer is attached (Fig 5.2.1, #7), turned on,
printer output is ON, and that the unit has and adequate supply of paper/labels (Section 7.8).
5.
Follow the appropriate procedure to collect the required samples.
