37754-6-1019
Page 45
MULTIFUNCTION REMOTE OPERATING INSTRUCTIONS
Initializing The System
1. Remove the wall cover. Open the wall mounted battery back-
up holder.
See Figure 68
. Install the four AA batteries and
reinstall the cover.
See Figure 69.
2. Install three AAA batteries into the battery bay located on the
base of the transmitter.
See Figure 70.
3. Set the wall remote slide switch to the REMOTE position.
See Figure 69.
4. Press and release the SWI button on the wall control with a
paper clip. The IFC module will beep three times to indicate
the IFC module is ready to synchronize with the transmitter
within ten seconds.
See Figure 69.
Figure 68
SWI
BUTTON
Figure 69
5. Push the On button. The Receiver will beep four times to
indicate the Transmitter’s command is accepted and set to
the code for that Transmitter. The system is now initialized.
Figure 70
Temperature Indication Display °C or °F
With the system in the OFF position, press the Thermostat Button
and the Mode Button at the same time. Look at the LCD screen
on the Transmitter to verify that a °C or °F is visible to the right of
the Room Temperature display.
See Figures 71 and 72.
Figure 71
Figure 72