![background image](http://html.mh-extra.com/html/empire-comfort-systems/boulevard-multifunction-remote-dvll48sp/boulevard-multifunction-remote-dvll48sp_installation-instructions-and-owners-manual_2404037028.webp)
37754-6-1019
Page 28
INSTALLATION (CONT’D)
Finishing Options
•
Non-Combustible board installed over the fireplace face
(framing bracket flush).
See Figures
32 and 33.
•
Non-Combustible board installed flush to face (framing
brackets at 1/2 or 3/4 inch set back).
See Figures 30 and 31.
•
Exterior wall finishing (w/outdoor kit DFED48955).
See page 28.
•
Use Non-Combustible materials where indicated for the
fireplace installation. Non-combustible materials do not ignite
or burn as a result of using the fireplace. These include
metal, brick, ceramic, concrete, slate, glass and plaster.
Adhesives must be rated for high temperatures. Any
mechanical fasteners used to install material must also be
non-combustible, including wall anchors and tile spacers.
Materials that pass the ASTM E 136 test (Standard Test
Method for Behavior of Materials in a Vertical Tube Furnace
at 750C) are considered non-combustible.
NotICE:
Cold climate installation recommendation: When
installing this fireplace against a non-insulated exterior wall, it
is recommended that the outer walls be insulated to conform to
applicable insulation codes.
Interior Wall Installation
Non-combustible Board - Flush to Face
2” X 4”
HEADER
NAILING
FLANGE
JOINT BETWEEN
FINISHED WALL
AND UNIT SEALED
WITH 300°F
(149°C) SEALANT
FINISHED WALL
(COMBUSTIBLE)
NON-COMBUSTIBLE
BOARD
Figure 30
Flush to Face - Framing & Finishing
Figure 31
Interior Wall Installation
Non-combustible Board - Over Fireplace Face
2” X 4”
HEADER
NAILING
FLANGE
NON-COMBUSTIBLE
BOARD
FINISHED WALL
(COMBUSTIBLE)
Figure 32
Over Fireplace Face - Framing & Finishing
Figure 33