![background image](http://html.mh-extra.com/html/empire-comfort-systems/boulevard-multifunction-remote-dvll48sp/boulevard-multifunction-remote-dvll48sp_installation-instructions-and-owners-manual_2404037051.webp)
37754-6-1019
Page 51
Lockout State Definition
To prevent damage to the fireplace, IFC board will automatically
lockout the remote control if it detects a anomalous flame or
too many unsuccessful ignition attempts. The lockout state will
remain as long as the power supplies are applied.
When the IFC board goes into lockout state:
1. both the Pilot and the Main Burner solenoids in the gas valve
are de-energized;
2. a diagnostic code is sent through the diagnostic red LED.
3. the IFC board will ignore any burner ignition command
and remain in the OFF state unless the unlock command
sequence is met.
Turn the system power supplies (to the wall control or remote
control) OFF for two or three seconds and then restore power.
If the lockout reoccurs, call your dealer. The causes of lockout
must be investigated under safe conditions by trained service
personnel.
Using the Fireplace without a Remote Control
The fireplace can be turned ON (HI only) and OFF with the wall
switch. The fireplace flame ON/OFF is the only function that will
operate; no flame adjustment, or light will work when using the
wall switch. The wall control switch should be turned OFF when
the fireplace is not being used for extended periods of time.
Battery Backup Operation
Install batteries (See initialization sequence on page 69). In
case of power loss, the fireplace will switch to battery mode
automatically. The fireplace will operate normally without the fan
or light control when in battery mode.
Low Battery Detection
When the backup batteries are low, the module emits a double-
beep when it receives an on/off command. The system will not
accept any commands until the batteries are replaced or A/C
power is restored.
MULTIFUNCTION REMOTE OPERATING INSTRUCTIONS