![background image](http://html.mh-extra.com/html/empire-comfort-systems/boulevard-multifunction-remote-dvll48sp/boulevard-multifunction-remote-dvll48sp_installation-instructions-and-owners-manual_2404037059.webp)
37754-6-1019
Page 59
MAINTENANCE AND SERVICE (CONT’D)
Figure 98
Figure 99
Maintenance
Maintenance frequency must be determined individually for each
application. Some considerations are:
•
Exposure to water, dirt, chemicals and heat can damage the
gas control and shut down the control system.
•
Cycling frequency. Fireplaces that may cycle 20,000 times
annually should be checked monthly.
•
Intermittent use. Fireplaces that are used seasonally should
be checked before shutdown and again before the next use.
•
Dusty, wet or corrosive environment. Because these
environments can cause the gas control to deteriorate more
rapidly, the system should be checked more often.
•
Any control should be replaced if it does not perform properly
on checkout or service. In addition, replace any module if it
is wet or looks like it has been wet.
Service
Do not disassemble the gas control; it contains non-replaceable
components. Attempted disassembly or repair can damage the
control.
Exactly follow the warnings and the lighting instructions.
1. Before lighting, smell around the fireplace area for gas. If
the fireplace uses Propane (bottled) gas, be sure to smell
next to the floor because Propane Gas is heavier than air. If
you smell gas, immediately shut off the manual valve in the
gas piping to the fireplace or on Propane at the tank. Do not
try to light any appliance. Do not touch any electrical switch
or use the phone. Leave the building and call your gas
supplier. If your gas supplier cannot be reached, call the fire
department.
2. The gas control must be replaced if it has been flooded with
water. Call a qualified service technician.
3. The gas control is a safety device. It must be replaced
in case of any physical damage such as bent terminals,
missing parts, stripped threads, or evidence of exposure to
excessive heat.
Follow the operating instructions provided by the manufacturer of
your appliance.
NotICE:
It is normal for fireplaces fabricated of steel to give
off some expansion and/or contraction noise during the start up
or cool down cycle. Similar noises are found with your furnace
heat exchanger or car engine. It is normal for your gas fireplace
to give off some odor the first time it is burned. This is due to
the curing of the paint and oil from the manufacturing process.
Please ensure that your room is well ventilated - open a window.
Burn your fireplace for at least one hour the first time you use it.
IMPORTANT:
Turn off gas before servicing fireplace. Have a
qualified service person perform these check-ups once a year
preferably before the using of the fireplace.
Clean Burner and Control Compartment
Keep the control compartment and burner area clean by
vacuuming or brushing at least twice a year.
Cleaning Procedure
1. Turn off fireplace.
2. Remove the barrier screen and glass door assembly. See
Glass Door Removal.
3. Remove decorative media (a clean portable shop-vac is
recommended).
4. Vacuum burner cover and burner screen areas.
5. Replace decorative media. See page 43.
6. Reinstall the glass door and barrier screen.
7. Ignite fireplace. See Lighting Instructions.
8. If flame appears abnormal, call a service person.
Check Vent System
The fireplace and venting system should be inspected before
initial use and at least annually by a qualified service person.
Inspect the external vent cap on a regular basis to make sure that
no debris is interfering with the air flow.