Emerson Rosemount ET310, Quick Start Manual

Page: 23 / 52

3.5 Fitting the lanyard
WARNING
Use supplied lanyard to prevent sensor falling from heights, potentially
causing injury
Procedure
1. Wrap the lanyard around the circumference of the pipe, on top of
any cladding.
Note
The 7 ft (2 m) lanyard is sufficient for a pipe diameter up to 20 inches.
When it is not possible to wrap the lanyard around a pipe, find an
alternative attachment point for the lanyard.
Tip
For pipes exceeding 20 inches in diameter, lanyards may be linked
together. For sensors in close proximity to each other, a single
lanyard may be used.
2. Thread the bare end of the wire through the loop in the lanyard to
secure it to the pipe.
3. Feed the bare end of the lanyard into the cable lock and push the lock
up the lanyard.
WARNING
Take special care when the bare end of the lanyard is fed through the
tensioner. Do not put fingers under bolts of the tensioner.
January 2022 Quick Start Guide
Quick Start Guide 23