Emerson Rosemount 5600 Series, Reference Manual

Page: 87 / 128

87
Reference Manual
00809-0100-4024, Rev CA
HART Configuration
March 2020
HART Configuration
5.4.1 HART fast keys
5.4.2 Setting the loop to manual
Whenever sending or requesting data that would disrupt the loop or change the output of the
transmitter, set the process application loop to manual. The HART Communicator will prompt you to set
the loop to manual when necessary. Acknowledging this prompt does not set the loop to manual. The
prompt is only a reminder; set the loop to manual as a separate operation.
5.4.3 Connections and hardware
The HART Communicator exchanges information with the Rosemount 5600 from the control room, the
instrument site, or any wiring termination point in the loop. The HART Communicator should be
connected in parallel with the transmitter. Use the loop connection ports on the rear panel of the HART
Communicator. The connections are non-polarized.
Do not make connections to the serial port or NiCad recharger pack in an explosive atmosphere.
5.4.4 Using a handheld communicator
Note
Remember, when using a handheld communicator, you must send the data before configuration
changes will take effect.
5.4.5 Level configuration example
To configure the Rosemount 5600 to report LEVEL (analog output is linear to level) with the transmitter
wired as on
page 60 , connect the handheld communicator as shown.
Function HART Fast Key
Antenna Type 1, 3, 3, 1
Basic Volume 1, 3, 3, 7
Device Information 1, 4, 1
Diagnostics 1, 2, 1
Distance Unit 1, 3, 1, 1
Poll Address 1, 4, 2, 1
Primary Variable 1, 1, 1, 1
PV Alarm Mode 1, 3, 4, 1, 4
PV Lower Range Value 1, 3, 4, 1, 3
PV Upper Range Value 1, 3, 4, 1, 2
PV Source (Assignment) 1, 3, 4, 1, 1
Software Version 1, 2, 2, 3
Surface Search 1, 2, 3
Tank Height 1, 3, 3, 3
Temperature 1, 3, 3, 8