PACSystems™ Industrial Displays User Manual
Section 3
GFK-3138B
Jul 2021
Hardware
78
3.2.2
I/O and Connectors
Outside I/O
The rear panel I/O port arrangement consists of the following:
•
1 power button
•
1 24V DC-in 3-pin power connector
•
1 DP++
•
2 USB 3.0 ports
•
2 RJ45 LAN ports
•
1 UART terminal-block
•
1 Line-out jack
•
1 Mic-in jack
Figure 68: Rear Panel Arrangement
Connecting Input Power (24V DC-in)
To connect to power, follow these steps:
2.
Verify that the power cable is not energized.
3.
Loosen the screw clamps on the mating power connector.
4.
Strip the insulation from the power cables.
5.
Secure the power cable to the mating connector, noting
polarity, and tighten the screw clamps. The torque for the
attaching screws is 0.3 Nm (2.26 in-lb).
6.
Apply dc power to the unit. During normal startup and
operation, the LED status indicator displays as follows:
•
Solid amber while the RXi - Industrial Display unit is starting up
•
Solid green during normal operation
