22
IC695CPE400 Rackless CPU Quick Start Guide
GFK-3002G
Basic Start-up Steps
For startup and configuration of the CPE400, complete the following steps.
For full details on CPE400 operation, refer to the
PACSystems RX3i and CPU
Reference Manual,
GFK-2222.
1.
Mount the CPE400, as described in section
and per the
Installation and Maintenance Requirements
document, GFK-3004.
2.
Attach the user-supplied power supply cable as described in if no
Energy Pack is being used.
3.
(optionally) Mount and attach the compatible Energy Pack,
IC695ACC403, as described in the
PACSystems RX3i Rackless Energy
Pack IC695ACC403 Quick Start Guide,
GFK-3000.
4.
Turn on the power supply unit: the unit should then run without the
need to press any buttons.
5.
If not previously configured, configure the RX3i PLC using PME 9.00
SIM 8 or later, as described in the
Note: When the ACC403 Energy Pack is powered up, a finite period is
required to charge it up to its operating level. During this time, the Energy
Pack will indicate this condition via its LEDs (refer to the
PACSystems RX3i
Rackless Energy Pack IC695ACC403 Quick Start Guide,
GFK-3000).
The CPE400 will begin its boot cycle immediately upon power application.
However, the embedded controller will not start its control until the
ACC403 is charged. This typically takes 45 seconds or less. In the event the
ACC403 is faulty or is not communicating, CPE400 commences operation
without the Energy Pack.
