Emerson Micro-Motion 2400S, Configuration And Use Manual, Page: 31 / 198

Configuration and Use Manual 23
Req
u
ir
ed
Con
fig
uration
O
pt
ion
a
l Co
nfi
g
u
ratio
n
Using the
T
ransmitter
Flo
w
me
te
r Sta
rtup
Chapter 5
Flowmeter Startup
5.1 Overview
This chapter describes the procedures you should perform the first time you start the flowmeter
system. You do not need to use these procedures every time you cycle power to the transmitter.
The following procedures are discussed:
• Applying power to the transmitter – see Section 5.2
• Performing a loop test on the transmitter outputs – see Section 5.3
• Trimming the mA output – see Section 5.4
• Zeroing the meter (optional) – see Section 5.5
Figure 5-1 provides an overview of the startup procedures.
Figure 5-1 Startup procedures
Note: All ProLink II procedures provided in this chapter assume that your computer is already
connected to the transmitter and you have established communication. All ProLink II procedures also
assume that you are complying with all applicable safety requirements. See Chapter 3 for more
information.
Note: If you are using Pocket ProLink or AMS, the interface is similar to the ProLink II interface
described in this chapter.
Note: All Communicator procedures provided in this chapter assume that you are starting from the
“Online” menu. See Chapter 4 for more information.
Apply power
Zero the
meter (optional)
Perform
loop tests
Trim mA output(s)
(if necessary)
Start
Finish