Emerson Micro-Motion 2400S, Configuration And Use Manual, Page: 160 / 198

152 Micro Motion
®
Model 2400S Transmitters with Analog Outputs
Troubleshooting
Figure 11-1 Accessing the feedthrough pins
5. Using a digital multimeter (DMM), check the sensor internal resistances for each flowmeter
circuit. Table 11-9 defines the flowmeter circuits and the resistance range for each. Refer to
Figure 11-2 to identify the feedthrough pins. For each circuit, place the DMM leads on the pin
pairs and record the values.
Note: In order to access all feedthrough pins, you may need to remove the clamp and rotate the
transmitter to a different position.
In this test:
• There should be no open circuits, i.e., no infinite resistance readings.
• Nominal resistance values vary 40% per 100 °C. However, confirming an open or shorted
circuit is more important than any slight deviation from the resistance values shown here.
• The LPO and RPO circuit readings should be the same or very close (± 10%).
• The readings across pin pairs should be steady.
• Actual resistance values depend on the sensor model and date of manufacture. Contact
Micro Motion for more detailed data.
If a problem appears, or if any resistance is out of range, contact Micro Motion (see
Section 11.3).
Table 11-9 Nominal resistance ranges for flowmeter circuits
Circuit Pin pairs Nominal resistance range
(1)
Drive Drive + and – 8–1500
Ω
Left pickoff Left p and – 16–1000
Ω
Right pickoff Right p and – 16–1000
Ω
Transmitter
(side view)
Sensor cable for
feedthrough connection
Feedthrough connector
Snap clip (assembled)
Pull tab to remove
Feedthrough pins