3410 Series Gas Ultrasonic Meters Operations Manual
Section 2: Setup meter communications
3-9000-777 Rev E
January 2018
Setup the meter directory
5
b. Modem connection - set the following properties to connect to the meter via a
modem.
–
Protocol and Comms Address: Use the Protocol and Comms Address
parameters in
Step 3 a.
–
Modem: Select the modem to use from the drop-down list. Only modems
installed in Windows® show in the drop-down list. If the drop-down list is
blank, then no modems have been installed for Windows®.
Note
: Do not select Daniel Direct Connection or Communications cable
between two computers for the modem. This is a NULL modem driver for
direct connection to Daniel Ultrasonic meters only. It will not work for the
Modem connection.
Daniel MeterLink uses the Microsoft® Dial-up Networking for making
modem and direct serial connections to a meter. Click
Modem Properties
to
bring up the Dial-up networking entry Daniel MeterLink™ has created for
this meter. Most of the information required is setup correctly by Daniel
MeterLink™.
–
Baud Rate: Select the desired Baud Rate from the drop-down list.
–
Telephone #: Enter the telephone number for the modem to which the
meter is connected. Include digits to obtain to an outside line, if necessary.
Inserting commas between the digits pauses the dialing rate. Each comma
is approximately equal to two seconds.
–
Modem Properties: configures the properties associated with the modem.
Daniel MeterLink uses the Microsoft® Dial-up Networking for making
modem and direct serial connections to a meter.
Click
Modem Properties
to bring up the Dial-up networking entry Daniel MeterLink has created for
this meter. Most of the information required is setup correctly by Daniel
MeterLink. Click
OK
to accept the changes or click
Cancel
to discard any
changes and return to the Meter Directory dialog box.
