EMBRON Hatteland HD 19T22, User Manual, Page: 36 / 142

36
Installation Procedures
Installation
IND100078-33
▼ 5: You may now mount the unit onto your desired location. It is advised that you unlock the Lock Pin (as shown in
step 4), tilt the unit 90° backwards (FIG1) and properly fasten the bracket base into location (FIG2).
NB! Be careful not to break or scratch the edge of the front glass! Then repeat step 4 again until your desired
tilting position has been achieved and you have verified that the Lock Pin are in locking position and the unit is firmly
attached and does not appear loose (FIG3).
Unlock, tilt and lock
FIG1
FIG2
Top View
Use appropriate fasteners
6 pcs x M6 needed
FIG3
Re-check Lock Pins!
▼ Alternative Mounting: Depending on installation needs, you may mount the complete unit in ceiling in two different ways.
Upside Down Position: User Controls will be upside down, cables go straight up. You may configure Glass Display Control ™
(GDC) LED symbols to show or not, since symbols will be seen upside down. Displayed image needs to be flipped vertically.
Review the appropriate SCOM manuals (“Glass Display Control™ (GDC) LED & Button operations” section).
Normal Position: User Controls readable, no image flip needed, cables has to bend up or go straight down.
Upside Down Normal Position