EMBRON Hatteland HD 19T22, User Manual

Page: 31 / 142

31 Installation
IND100078-46
Installation Procedures
Panel Cutout / Console Mounting Bracket Kit for 24 and 27 inch
You need: Torx T25 tool, 1 pcs of HD CMB SX2-E1 kit (included in delivery).
Procedure suitable for: Display and Panel Computers Series X Generation 2 range. Brackets are EN60945 Tested.
Attention: A suitable pre-cut panel cutout should be made prior to mounting. Do not force the
unit into the panel cutout as it might break the outer glass or scratch the chassis on the unit. Make
sure that the panel cutout is not too tight for the unit. Please disconnect ALL cables before
proceeding. Please re-check the relevant and required panel cutout measurements if unsure.
Item Amount Art Description Notes
3 P006858-1 Bracket HD 24T21 SH-A
1 P020605 HD 2xT2x CMB Bottom
6 145 050x016 A4T M5x16 Pan Head screw ISO 14583 Torx, A4 For P006858-1
6 144 064x120x22 M6 C-washers DIN6319 Steel For P006858-1
2 145 050x016 CA4 DIN 965 M5x16 Countersunk head screws with TX25, A4 STAINLESS STEEL For P020605
▼ 1: Slide the unit into the cutout carefully. User
Controls and Connector Area should be facing
downwards.
▼ 2: Make sure you are aware that brackets should be
mounted on TOP, LEFT, RIGHT and BOTTOM sides.
Note that the [B] bracket is different than the [A] brackets
and mounted near the connectors. See closeup of details.
[A]
[B]
[A]
[A] [A]
[B]
▼ 3: Secure each bracket with the provided screws as
illustrated below. Make sure you do it equally and even
for all 4 sides. Use Torque Force 3.75Nm. Note the
orientation of brackets before you begin.
▼ 4: Review closeup of the mounting of brackets with
screws. Seen from bottom side.
Washer
Washer
Screw
Screw
Bracket