EMBRON Hatteland HD 19T22, User Manual, Page: 127 / 142

127
IEC62368 policy for Hatteland Technology products
IND100078-80
Authority Description
Children This equipment is not suitable for use in locations where children are likely to be present.
Ordinary person/
Sailor/End-User
Not allowed to open unit.
Not allowed to install the unit.
Not allowed to terminate/connect cables to the unit.
Instructed person Allowed to open hatches/latches which does not require tools, such as Disktrays.
Allowed to open "battery-hatch" to change the battery even if tools are required.
Allowed to install the unit.
Allowed to terminate/connect cables to the unit indoors.
Skilled person
Allowed to open and disassemble the unit.
Allowed to install the unit.
Allowed to terminate/connect cables to the unit indoors and outdoors.
Allowed to terminate/connect earth/ground wire.
Note: Be aware that additional definition for “skilled person” may apply, country dependent.
Conditions Description
AC power net Class
Class 1.
Pollution degree 2.
Over voltage category 2.
Transient requirement
External circuits are considered to be installed wholly within the same building structure.
Battery Obligated to use battery specified for the product.
Altitude Products are designed for a max operating altitude of 2000m.
Installation Description
Mounting brackets Only bracket defined/specified for the unit is allowed.
AC power cord When installed it shall be possible to disconnect the unit from the AC power net
i.e. possible to reach AC connecter.
Transient requirement External circuits are considered to be installed wholly within the same building structure.
Earthing Obligated to use defined earthing material/method specified for the unit.
Minimum protective bonding conductor size of copper conductors:
Wire: Minimum 1,5mm
2
but Hatteland Technology recommends 2,5mm
2
(AWG12)
marked yellow/green.
Outdoor Units with IP66/67-rated fronts can be used in outside environments, provided that the
console they are fitted in fulfil certain requirements.
- There must be a fully water/dustproof seal between the IP66 front and the console.
- Dust/water ingress protection of console. (Unit/product is rated for pollution degree 2).
- Humidity/condensation control in console.
- Thermal management in console (so units can operate within rated temperature range).
Units with IP20/IP22 shall not be used outdoor.
Outdoor Installation Appropriate RCD with ground current rating of 20mA or less shall be used.