EMBRON Hatteland HD 19T22, User Manual

Page: 29 / 142

29 Installation
IND100078-66
Installation Procedures
Panel Cutout / Console Mounting Bracket Kit for 19 inch
You need: Hex tool (5mm), 1 pcs of HD CMB SX2-N1 Kit (included in delivery).
Attention: A suitable pre-cut panel cutout should be made prior to mounting. Do not force the
unit into the panel cutout as it might break the outer glass or scratch the chassis on the unit. Make
sure that the panel cutout is not too tight for the unit. Please disconnect ALL cables before
proceeding. Please re-check the relevant and required panel cutout measurements if unsure.
▼ 1: Mount one of the flat brackets on any side on
rear of unit first with 3 x M5x12 Countersunk Hex
screws as illustrated and fasten it using Torque Force
3.75nm
▼ 2: Tilt the unit 45 degree to allow the flat bracket to enter
cutout first, then tilt it back 45 degree and slide the entire
unit into the cutout evenly and carefully. User Controls and
Connector Area should be facing downwards.
▼ 3: Once unit is in place, mount the other flat bracket
on the other side with 3 x M5x12 Countersunk Hex
screws as illustrated and fasten it using Torque Force
3.75nm
▼ 4: Prepare 4 pcs of Thumb screw and Mounting
Socket Nut in separate form as illustrated below.