57
GB
Water supply
We recommend that you use an authorised installer
to connect to the water supply.
Connect the supply hose as shown in the diagram.
1. Connect the elbow to the water tap and turn
clockwise to tighten.
2. Connect the other end of the supply hose to the
inlet valve at the rear of the washing machine
and tighten it securely (clockwise).
Note! If there is any leakage from the hose after connection, repeat all the steps for
connecting the supply hose. Use a conventionally designed tap to supply the water.
If the tap has a square spout or is too large in diameter you should replace it with
a standard tap.
Drain hose
There are two ways to connect the drain hose:
Alternative 1: Connect it to a waste pipe. This method is suitable if there is a
suitable coupling accessible.
The drain hose must not rise more than 100 cm above
the floor.
Alternative 2: Connect to a sink or open drain.
•
Secure he drain hose once it has been installed.
•
Position the drain hose so that water cannot
leak on to the floor.
Installation
M
ax.100c
m
Min.60c
m
Max.100cm
Min.60cm
Min.60
cm
M
ax.100c
m
Vattenho
Upphägningsbygel för
dräneringsslang
Uppfästning
Support for drain hose
Water drai
n
Clip
