WOP-2ac-LR2. User manual
34
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
General VLAN ID
– a tag will be removed from the specified VLAN ID and the traffic of this VLAN will
pass to the client without a tag. When traffic passes in the opposite direction, untagged traffic will be
tagged with General VLAN ID;
Station Isolation
– when checked, traffic isolation between clients in the same VAP is enabled;
Maximum Stations
– the maximum number of clients connected to the virtual network;
Security
– wireless access security mode:
Off
– do not use encryption for data transfer. The access point is available for any subscriber to
connect;
WPA, WPA2, WPA/WPA2 –
encryption methods, if you select one of the methods, the following
setting will be available:
WPA Key –
key/password required to connect to the virtual access point. The length of the
key makes from 8 to 63 characters;
WPA-Enterprise, WPA2-Enterprise, WPA/WPA2-Enterprise –
wireless channel encryption mode, in
which the client is authorized on the centralized RADIUS server. To configure this security mode,
you must specify the parameters of the RADIUS server. You also need to specify a key for the
RADIUS server. If you select one of the methods, the following setting will be available:
Domain – user domain;
IP Address of RADIUS Server –
RADIUS server address;
Port of RADIUS Server
– port of the RADIUS server that used for aithentication and
authorization;
Password of RADIUS Server
– password for the RADIUS server used for authentication and
authorization;
Use Accounting through RADIUS –
when checked, 'Accounting' messages will be sent to the
RADIUS server;
Use Other Settings For Accounting
IP Address of RADIUS Server for Accounting
–
address of the RADIUS server, used for
accounting;
Port of RADIUS Server for Accounting
– port that will be used to collect accounts on
the RADIUS server;
Password of RADIUS Server for Accounting –
password for the RADIUS server used for
accounting;
Use Periodic Accounting –
enable periodic sending of 'Accounting' messages to the
RADIUS server. You can set the interval for sending messages in the 'Accounting
Interval' field.
Shapers
Show –
display configuration field;
VAP Limit Down
– restriction of bandwidth in the direction from the access point to the clients (in total)
connected to this VAP, Kbps;
VAP Limit Up
– restriction of bandwidth in the direction from the clients (in total) connected to this VAP,
to the access point, Kbps;
STA Limit Down
– restriction of bandwidth in the direction from the access point to the clients (each
separately) connected to this VAP, Kbps;
STA Limit Up
– restriction of bandwidth in the direction from the clients (each separately) connected to
this VAP, to the access point, Kbps.
