ELTEX MES23xx, Operation Manual

Page: 118 / 208

MES53xx, MES33xx, MES23xx Ethernet Switch Series 118
ipv6 pim ssm {range
ipv6_multicast_subnet |
default}
-
Specify a multicast subnetwork
-
range - specify a multicast subnetwork;
- ipv6_multicast_subnet - multicast subnetwork;
- default - specify a range in FF3E::/32.
no ipv6 pim ssm [range
ipv6_multicast_subnet |
default]
-
Disable this parameter.
ipv6 pim rp-embedded
-/enabled
Enable extended functions of a rendezvous point (RP).
no ipv6 pim rp-embedded Disable extended functions of a rendezvous point (RP).
Ethernet interface configuration mode commands
Command line prompt is as follows:
console(config-if)#
Table 5.112. Ethernet interface configuration mode commands
Command Value/Default value Action
ip (ipv6) pim
-/enabled
Enable PIM on an interface.
no ip (ipv6) pim Disable PIM on an interface.
ip (ipv6) pim bsr-border
-/disabled
Stop sending BSR messages from an interface.
no ip pim bsr-border Disable this parameter.
ip (ipv6) pim dr-priority
priority
priority: (0..4294967294)/1
Specify the priority in selecting a DR router.
-
priority - the priority to determine which switch will be a DR
router. The switch that has the highest value will be a DR
router.
no ip (ipv6) pim dr-priority Return the default value.
ip ip (ipv6) pim
hello­interval
secs
secs: (1..18000)/30 seconds
Specify a sending period for hello packets.
-
sec - hello packet sending period.
no ip (ipv6) pim
hello­interval Return the default value.
ip (ipv6) pim
join­prune­interval
interval
interval: (1..18000)/60
seconds
Specify a time period during which the switch will send join or
prune messages.
-
interval - join or prune messages sending interval.
no ip (ipv6) pim
join­prune­interval Return the default value.
ip (ipv6) pim
neighbor­filter
acc_list
acc_list: (0..32) characters.
Filter incoming PIM messages.
-
acc_list - the list of addresses to filter.
no ip (ipv6) pim
neighbor­filter Disable this parameter.
EXEC mode commands
Command line prompt in the EXEC mode is as follows:
console#
Table 5.113. EXEC mode commands
Command Value/Default value Action
show ip (ipv6) pim rp mapping
[
RP_addr ]
-
Show active RPs linked to routing information.
-
RP_addr – IP-address.
show ip (ipv6) pim neighbor
[detail]
[gigabitethernet
gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channel group |
vlan vlan_id ]
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4);
group: (1..16);
vlan_id: (1..4094).
Show information about PIM neighbours.
show ip (ipv6) pim interface
[gigabitethernet
gi_port |
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
Show information about PIM interfaces:
-
state-on - displays all interfaces on which PIM is enabled;