ELTEX MES23xx, Operation Manual

Page: 73 / 208

MES53xx, MES33xx, MES23xx Ethernet Switch Series 73
console(config-if)#
Table 5.40. Ethernet interface configuration mode commands
Command Value/Default value Action
storm-control multicast
[registered |
unregistered]{level
level |
kbps kbps } [trap]
[shutdown]
level: (1..100);
kbps: (1..10000000)
Enable multicast traffic control:
-
registered - registered traffic;
- unregistered - unregistered traffic.
- level - traffic volume as a percentage of the interface
bandwidth;
-
kbps - traffic volume.
If multicast traffic is detected, the interface may be disabled
(
shutdown) , or a record is added to log ( trap ).
no storm-control multicast Disable multicast traffic control.
storm-control unicast
{level
level | kbps kbps }
[trap] [shutdown]
level: (1..100);
kbps: (1..10000000)
Enable unicast traffic control.
-
level - traffic volume as a percentage of the interface
bandwidth;
-
kbps - traffic volume.
If unicast traffic is detected, the interface may be disabled
(
shutdown ), or a record is added to log (trap).
no storm-control unicast Disable unicast traffic control.
storm-control broadcast
{level
level | kbps kbps }
[trap] [shutdown]
level: (1-100);
kbps: (1..10000000)
Enable broadcast traffic control.
-
level - traffic volume as a percentage of the interface
bandwidth;
-
kbps - traffic volume.
If broadcast traffic is detected, the interface may be disabled
(
shutdown ) , or a record is added to log (trap).
no storm-control broadcast Disable broadcast traffic control.
EXEC mode commands
Command line prompt in the EXEC mode is as follows:
console#
Table 5.41. EXEC mode commands
Command Value/Default value Action
show storm-control interface
[gigabitethernet
gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port ]
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4)
Show broadcast storm control configuration for the selected
port or all ports.
Examples of command usage
Enable broadcast, multicast or unicast traffic control for Ethernet interface no. 3. Set the transfer
rate for controlled traffic: 5,000 kbps for broadcast traffic, 30% of the bandwidth for multicast traffic, 70%
for unicast traffic.
console# configure
console(config)# interface TengigabitEthernet 0/3
console(config-if)# storm-control broadcast kbps 5000 shutdown
console(config-if)# storm-control multicast level 30 trap
console(config-if)# storm-control unicast level 70 trap
5.12
Link Aggregation Groups (LAG)
The switches support Link agregation groups (LAG) in the number corresponding to Table 2.9. Main
specifications (‘Link aggregation group
(LAG)’
). Each port group should include Ethernet interfaces
operating at the same speed in full-duplex mode. Aggregation of ports into group will increase bandwidth