MES53xx, MES33xx, MES23xx Ethernet Switch Series
93
Commands for global configuration mode
Command line prompt in the global configuration mode is as follows:
console(config)#
Table 5.80 – Commands for a global configuration mode
Command
Value/Default value
Action
erps
-/disable
Allow ERPS protocol operation.
no erps
Forbid ERPS protocol operation.
erps vlan
vlan_id
vlan_id:(1..4094)
Create ERPS rings with R-APS VLAN ID through which you will
be able to transmit service information and proceed to the
ring configuration mode.
-
vlan_id
– R-APS VLAN ID.
no erps vlan
vlan_id
Delete ERPS ring with
vlan_id
identifier.
Commands for ring configuration mode
Command line prompt in the ring configuration mode is as follows:
console(config-erps)#
Table 5.81 – List of commands for ERPS ring configuration mode
Command
Value/Default value
Action
protected vlan add
vlan_list
vlan_list:(2..4094, all)
Add a VLAN range in the list of secure VLAN.
-
vlan_list –
VLAN list. You may set a VLAN range separated by
comma or set initial and final values of the range with hyphen
"-".
protected vlan remove
vlan_list
vlan_list:(2..4094, all)
Delete VLAN range from the list of the secure VLAN.
-
vlan_list –
VLAN list for deletion.
port
{west | east}
{gigabitethernet
gi_port
|tengigabitethernet
te_port
|fortygigabitethernet
fo_port
}
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4)
Select west(east) port of the switch connected to the ring.
noport
{west | east}
Delete west(east) port of the switch connected to the ring.
rpl {west | east} {owner |
neighbor}
-/no rpl
Select RPL port of the switch and its roles.
-
west
– west port will be set as RPL port;
-
east
– east port will be set as RPL port;
-
owner
– switch will be owner of RPL port;
-
neighbor
– switch will be neighbor of the RPL port owner.
no rpl
Delete RPL port of the switch.
level
level
level: (0..7)/1
Configure the level of the R-APS messages. It is required for
providing the messages through CFM MEP.
-
level –
level of the
R-APS messages.
no level
Set the default value.
ring enable
-/disabled
Enable ring.
no ring enable
Disable ring.
version
version
version: (1..2)/2
Select the compatibility mode for other G.8032 protocol
version.
-
version –
G.8032 protocol version.
no version
Set the default value.
revertive
-/revertive
Select the ring operation mode.
no revertive
Set the default value.
sub-ring vlan
vlan_id
vlan_id:(1..4094)
Set the subring for the ring.
-
vlan_id –
VLAN ID number.
