ELSA LANCOM Business LC-4X00, Manual

Page: 239 / 276

Description of the menu options
ELSA LANCOM Business
R69
Setup/SNMP-module
This menu allows you to enter settings for configuration of the router via SNMP. The
menu has the following layout:
Send-Traps This entry controls trap output (No/Yes).
IP -Trap-Table Enters the IP addresses to which the trap messages will be sent.
Administrator Administrator's name
Location
Device location
You can also query the last two parameters via SNMP (MIB-2).
Register-
monitor This command logs on applications with the router to retain targeted trap information.
The
ELSA LANmonitor, for example, queries the channel statistics in this way and
converts them to a graphic display (under Windows).
In principle, any SNMP manager can use this command to obtain information from the
router. The syntax
register-monitor IP-address:port mac address timeout
is used to direct the router to enter the given address in the monitor table and to send
traps to it. If the traps are not received within the set hold time, the address will be
automatically deleted from the table. A hold time of '0' permanently retains the entry in
the table.
Delete-monitor This command removes the entries from the monitor table.
Monitor-table The monitor table has the following structure:
/SNMP-module SNMP module settings
Send-Traps Switch for issuing SNMP traps
IP-Trap-Table Table with 20 destination addresses for trap messages
Administrator Device administrator
Location Device location
Register-monitor Command to set a destination address to which the traps are to
be sent
Delete-monitor Command to delete an address that was set with 'Register-
monitor'
Monitor-table Table with all currently active destination addresses that were
set with 'Register-monitor'
IP-address Port MAC-Address Timeout
10.0.0.53 1057 0080c76da46e 1