ELSA LANCOM Business LC-4X00, Manual

Page: 30 / 276

Configuration modes
ELSA LANCOM Business
20
Configuration commands
Commands and path specifications are entered using the normal DOS or UNIX
conventions if you are using telnet (inband) or a terminal program (outband) to configure
the router.
Enter a forward slash or backslash to separate the path specifications. You do not need
to write out commands and table entries in full; an unambiguous abbreviation will do.
The entries for the categories MENU, VALUE, TABLE, TABINFO, ACTION and INFO will
be displayed while configurations are made to the router and may be modified. You can
use the following commands to do this:
This command ... ... means this ... ... for instance:
? or help calls up help text -
dir, list, ll, ls <MENU>,
<VALUE> or <TABLE> displays the contents of MENU,
VALUE or TABLE dir/status/wan-statistics displays the
current WAN statistics
cd <MENU> or <TABLE> switches to the MENU or TABLE
specified cd setup/tcp-ip-module (or cd se/tc
for short) switches to the TCP/IP mod-
ule
set <VALUE> this resets the value. set IP-address 192.110.120.140 sets a
new IP address
insert a space between all
entries in table rows. An *
leaves the entry unchanged. set /setup/name GLASGOW assigns
the name 'GLASGOW' to the device.
set <VALUE> ? shows you which values can be
specified here.
del <VALUE> deletes a a table row. del /se/wan/nam/GLASGOW
Deletes the entry for the remote sta-
tion GLASGOW.
do <ACTION>
(parameters) executes the ACTION according
to any parameters specified. do /firmware/firmware-upload starts
the upload of new firmware.
passwd allows a new password to be
specified. The old password, if
there is one, must be entered
first. The new password must
then be entered twice in a row
and confirmed each time with
Ü
.
repeat <sec> <ACTION> repeats the action at an interval
of the number of seconds speci-
fied. Any key can be used to ter-
minate the repetition. repeat 3 dir/status/wan-statistics
displays the current WAN statistics
every 3 seconds
time sets the system time and date. time 24.12.1998 18:00:00
language sets the language for the current
configuration session. Languages currently supported:
English (language English)
German (language German)
exit, quit, x configuration is terminated.