46
After inserting the SD
card/USB flash drive,
operations cannot be
performed.
The SD card/USB flash drive is not being read correctly. Use the SD card/USB flash
drive after formatting it twice as described below. First, format the card using a PC.
Then, format the card using the PX-10/30.
(⇒
P.29
)
The touchscreen does
not work properly.
・
Check that the touch points on the touchscreen are pressed correctly.
(⇒
P.23
)
No audio from the
external microphone.
・
The audio volume is too low. Go to the System Setting and adjust the volume (
⇒
P.28), or adjust the volume of the external microphone.
・
Go to the System Setting and check that "
External mic
” is selected in the “Sound
switch
”.
(⇒
P.28
)
The network function
does not work.
・
Check the network configuration of the PX-30 and the PC to be connected to the
PX-30.
The LAN cable cannot
be connected.
・
The LAN port (RJ45) is located on the rear panel of PX-30.
・
Check that the connector of the LAN cable is properly connected to the LAN port.
The LAN link LED does
not light up.
・
Power is not supplied to the PX-30 or to the device connected to the PX-30.
Check that the cable is connected firmly, and then turn on the power.
・
The cable is disconnected. Check the connection between the cable terminals.
・
Wrong cable is used. When a device to be connected to the PX-
30 is a PC, “LAN
cross cable” is used, and when it is a hub or router, “straight cable” is used.
Cannot connect to the
PX-30 from the client.
・
The IP address of the
PX-30 has not been designated. Designate the IP address
set in the PX-30.
・
The IP address of the client is not compatible with the network of the PX-30. To
establish the connection from the client to the PX-30, the network address should
be same between the client and the PX-30.
Default setting of the PX-30
:
DHCP
The set time will be
reset automatically.
・
The clock setting will be reset automatically after a long period of non-operation.
Then you will need to perform the clock setting again.
About the light (LED lighting)
The brightness of the LED lighting will diminish with long-term use. If its brightness has
significantly diminished, consult the dealer from whom you purchased PX-10/30 or our nearest
branch/office for replacement (subject to charge).
About long-term usage of this product
Due to the lifetime of its parts, if PX-10/30 is used for longer than the warranty period, its
performance and quality may deteriorate. In this case, we will replace the parts for a charge.
Consult the dealer from whom you purchased this PX-10/30 or our nearest branch/office.