45
➎
TROUBLE SHOOTING
◆
SYMPTOMS AND CONFIRMATION
Check the following items. If any abnormality is found, consult the dealer from whom you
purchased the PX-10/30 or our nearest branch/office.
Symptom
Possible cause/ remedy
No image is displayed.
・
The cable is not correctly connected.
・
The AC power cord is disconnected from the wall outlet.
・
The AC adapter is disconnected from the power inlet of the PX-10/30.
（⇒
P.20
）
・
The power is not on. (Power button: lit in blue)
・
If you turn on the power immediately after turning it off, the PX-10/30 may not start.
Wait for several seconds after turning the power off, and then turn it back on.
・
Reconnect the AC power cord.
・
Zoom is set to the TELE side, displaying only the white or black part of the
document.
（⇒
P.21
）
・
Wrong input source is selected. Set the correct input source from the Select image
menu.
（⇒
P.26
）
・
The output resolution setting of the connected monitor or projector does not match
that of the PX-10/30. Check the output resolution setting of the monitor or
projector.
（⇒
P.27
）
The output image
(resolution) changes
automatically.
・
The resolution setting is set to Auto. When the resolution setting is set to Auto, the
output resolution is automatically changed based on the information from the
connected device.
（⇒
P.27
）
No image is displayed
from the USB port.
・
No image will be output from the USB port when the USB mode is set to “Mass
s
torage (file transfer)”. Check the USB mode and select “UVC (image output)” from
the System Setting.
（⇒
P.28
）
The image is out of
focus
・
NThe document (subject) is too close to the lens. Move the document (subject)
slightly away from the lens.
The image is too dark.
・
The intensity of the lighting is insufficient. Turn on the LED lighting with the
Brightness button in the operating panel or adjust the Iris.
（⇒
P.22
、
P.23
）
・
Press the [ / ] buttons on the remote control to adjust the brightness.
The image is striped.
・
This may be interference fringes between dots of printed matter and TV scanning
lines or CMOS pixels. Changing the shooting range may improve the problem.
・
Vertical stripes may appear on an LCD projector image. Manually adjusting the dot
clock at the projector side may help the problem.
Images on the SD
card/USB flash drive
are not displayed.
・
Remove the SD card/USB flash drive, wait for a few seconds, and insert again.
（⇒
P.15
）
The image does not
move.
・
”Freeze” function is used. Press the Freeze button [ ] on the operating panel or
[ ] on the remote control to restart the live image feed.
（⇒
P.13
、
17
）
Not possible to operate
with the Remote
control.
・
The remaining battery level of the remote control is low. Replace the battery with a
new one.
・
Wrong remote control is used. Use the supplied remote control.
（⇒
P.17
）
