Elk ELK-M1EZ8 Installation Manual Download

Page: 34 / 68

M1EZ8 Installation and Programming

Page 34

[Effective w/Firmware 4.3.6]

Menu 07 - Global System Definitions

(continued)

Global Sys Definitions

Description of Option

Output 2 can be set to alarm only once per armed cycle for burglary type alarms. This
feature is intended for noise abatement. The dialer will continue to transmit all alarms that
may occur. THIS ONLY LOCKS OUT AUDIBLE FROM OUTPUT 2.

The control must be set to auto answer an incoming call in order for Remote Programming
(RP) to be accessed remotely. The range of rings can be set from 1 to 15. A value of “0”
disables auto answer.

A Yes enables faster connection from an outside telephone. It works as follows: Call the
control and hang up after 1 or 2 rings. This starts a 45 second timer. Call the control a
2nd time

during this 45 second time and

the control will answer on the first ring. In some

cases this Ring/Hang/Answer option may be the only way to get around telephone
company provided answering services.

Option 29 MUST also be set!

NOTE: If an on-site answering machine picks up, the RP software and the control
will automatically attempt to override the machine using tone sniffing methods.

Set this option to Yes ONLY when an ELK-M1TWI Two Way Listen-In interface is
installed. This enables the correct software commands and procedures to make the two
way functional. Refer also to the instructions that are shipped with the ELK-M1TWI

If Two Way is enabled, this timer provides a window for the CS to enter * 55 * and activate
two way listen-in by holding the phone line off-hook for 001 to 255 seconds after a kissoff.
Upon hangup, this timer re-starts to provide a window for the CS to callback and initiate
two way. Control will answer an incoming call on the first ring. Enter 000 to disable.

Allows the Central Station alarm verification by suspending (holding) new alarms after the
initial alarm kissoff. The phone line is kept free for this time period. The time value can be
from 001 to 255 seconds. Long time periods are not recommended. Enter 000 to disable.

This location is used to select the initial (default) baud rate for the on-board RS-232 serial
port which is Port 0. The available baud rates are: 0 or 1=300 baud, 2=1200, 3=2400,
4=4800, 5=9600, 6=14400, 7=19200, 8=38400, and 9=115200

The control can transmit ASCII data via it’s RS-232 port to automation types of equipment.
The ELK ASCII Protocol document is available upon request. This first option sets the
control to transmit all event log information immediately as it occurs.

This option sets the control to transmit zone status changes immediately as they occur.
The ELK ASCII Protocol document is available upon request.

This option sets the control to transmit output status changes immediately as they occur.

123456789012345678901234567890121234

G29:=00 Rings

Until AutoAnswer

123456789012345678901234567890121234

G28:=No Out2

SingleAlmLockout

123456789012345678901234567890121234

G35:=No Xmit

Event Log- ASCII

123456789012345678901234567890121234