Elitech FreezePoint 6000 Series, User Manual

Page: 43 / 138

43
Personnel: Lab supervisor
1. Complete all activities for installation and connection of the device.
2. Verify that the connections at the rear side of the device are secure.
3. Check the elevator for ease of movement.
If necessary, grease the elevator guide (
“8.5 Lubricate elevator” on page 96
).
4. Power up device on rear side using on/off switch.
5.1 Check printer (Models 6000P/SP)
5. Device does not ship with paper installed in the printer. On initial set-up see
“Replace printer paper (Models 6000P / 6000SP only)” on page 84 for
instructions on installing paper roll.
6. Check feed direction of paper roll. Open printer by pulling on silver knob
(magnetic latch).
Figure 22 Pull out printer
7. Compare feed direction of paper roll with feed direction shown.
Figure 23 Paper roll feed direction
Section 5: Setup