Elgas DATCOM, Operating Instructions Manual

Page: 184 / 228

Appendix
1: Device variant with the segment display
182
After the signal strength is successfully
measured, the value in percent (SIG: xx
[%], converted to dBm - see
Table 12
) is
displayed.
Automatic shutdown after 2 min or by
shutdown by the user.
MOD ON
Turning the modem power supply on
manually from the keypad
-
switches on, or switches on and
connects to GPRS according to the set
mode
-
the time in seconds to automatic exit
and shut down the of modem is
displayed
-
automatic shutdown after 5 minutes or
shutdown by the user
CALL
Manual initialization of GSM / GPRS calling
from the device to the master system
-
must be enabled in parameters
-
after activating the command, it
displays "Working"
-
then you can exit the mode and the
device performs the action
PACKET
displays the number of packets sent during
the active or last communication
BAT.EVC remaining battery capacity [%]
Vcc battery voltage
LATCH
Displays and freezes the actual values on
the display. This function is used to check
the field operation of the device
(abbreviated test). For Vb, Vbs, E, Es, the
decimal part of the value is displayed when
Enter is pressed.
8 DIAG Device Diagnostics
ACT.ST.
The current device status is displayed
(browse by pressing ENTER)
SUM.ST.
The device checksum is displayed (browse
by pressing ENTER)
SUM.CLR resetting total status
TEST triggering the device test
9 TARIFF
ID.CURR
ID.PREV
PREV.D
Note:
The number of display characters (digits) on the display at a time is limited to 10. If you need to display
longer information (such as ST.NAME - Station Identification), the displayed information will be scrolled.