Section 3: Configuration
IMAGESTAR HD USER GUIDE
Page 40
I460GB issue 4
Using ImageStar HD on a Network
In normal standalone operation, the
ImageStar HD
does not require a network connection.
However, to configure the unit, it is necessary to connect a PC/laptop (running the ISC App software)
to the device via its Ethernet port.
This can be achieved either by:
•
A direct connection between the PC and the
ImageStar HD
using a CAT5 crossover cable, or
•
An indirect connection via a network.
Whichever method is used, the network settings of the PC must be compatible with the ImageStar
HD,
i.e.
both devices must have the same Subnet Mask.
The
ImageStar HD
is shipped with the following default network settings:
IP Address:
192.168.0.65
Subnet Mask: 255.255.255.0
This enables the device to be connected directly to a Class C type network using IP Addresses in the
range 192.168.0.XXX provided that no other device is presently allocated the address 192.18.0.65.
Therefore, the PC must have the settings:
IP Address:
192.168.0.XXX
(where XXX is in the range 1 thru 254, but not 65)
Subnet Mask: 255.255.255.0
