Electronics Line infinite prime, Installation Manual, Page: 62 / 113

-62-
9.7.4: PGM Cut-off
The PGM Cut-off is the duration for which the PGM is activated. Certain Output Trigger
types are deactivated after the PGM Cut-off time has expired–
see Table 9.1: PGM
Output Trigger Options . For those Output Trigger types that are not affected by the PGM
Cut-off, there is no need to program this option.
To program the PGM Cut-off time:
1. From the Programming menu, select System Options, PGM Options,
PGM Cut-off [94074].
2. Enter a PGM Cut-off time (001-255 seconds or 000 for continuous activation).
3. Press
when the desired setting is displayed.
9.8: Guard Code (future option)
The Guard Code is a future option that is not available in the current firmware. The
default setting for this option is disabled. Electronics Line 3000 recommend that you do
not change this setting.
9.9: “No Arm” Indication
The “No Arm” indication is a feature designed to inform the central station that the
system has not been armed for a specified period of time.
To define the “No Arm” indication interval.
1. From the Programming menu, select System Options, No Arm Ind. [9409].
2. Select 1 Week, 2 Weeks, 3 Weeks, 4 Weeks or Disabled.
,
The No Arm event message is an unclassified event. This means that it does not belong
to any event group. If the No Arm option is programmed with any option other than
“Disabled”, the event message shall be sent.
9.10: Jamming Detection
The system is able detect RF Jamming that is usually caused by an intruder attempting
to compromise the security system.
To program the Jamming Detection setting:
1. From the Programming menu, select System Options, Jamming
Det. [9410].
2. Select Enabled or Disabled.
9.11: “No Motion” Time
The No Motion feature is designed to monitor the activity of disabled or elderly people. If
a sensor defined as “No Motion” (
see 7.6.1: Zone Type ) has not detected within a pre-
defined period of time, a No Motion event message is sent to the central station.
To program the No Motion time:
1. From the Programming menu, select System Options, No Motion [9411].
2. Enter the No Motion time value between either between 00:10 and
24:00 by 10 minute increments, 48:00, or 72:00. To disable the No
Motion feature, enter 00:00.