-35-
To view the TX list:
1. From the Service menu, select Transmitters, TX List [7071]; the first
transmitter on the list is displayed.
2. Using the arrow buttons, scroll through the transmitter list.
3. When you have finished viewing, press
to exit the list.
The TX list displays the following information for
each transmitter:
•
The zone/device number or descriptor.
Press the
key to toggle the display.
•
The signal strength of the last received
transmission.
•
An abbreviation indicating the last
received status of the transmitter
– see
Table 4.1
.
This… Means…
OK
The transmitter is functioning correctly
TA
Tamper condition
BT Battery
low
OS
The transmitter is out of synchronization
NA
The transmitter is inactive
– see 7.4: Supervision Time
Table 4.1: Transmitter Status Abbreviations
,
In most cases, an “out of synchronization” condition indicates that an unauthorized
attempt at grabbing the transmission has occurred – i.e. a previous transmission has been
recorded and sent by somebody trying to violate the system.
The second utility, TX Test, enables you to identify transmitters and test their
signal strength.
In TX Test mode, each time a transmission is received, the activated transmitter
is displayed.
If you enter this function using the Master code, a
chime is sounded every time a transmission is
received. If you enter this function using the
Installer code, a sequence of tones are sounded
indicating the transmitter’s signal strength –
see
Table 4.2.
This feature helps you to determine the
best location to install a transmitter.
To initiate TX Test mode:
1. From the Service menu, select Transmitters, TX Test [7072].
2. Activate a transmitter; the transmitter’s details are displayed.
3. When you have finished, press
to exit TX Test mode.
4.7.8: Audio Volume
To adjust the sensitivity of the microphone and the volume of the speaker:
1. Establish a two-way audio connection.
2. From the Service menu, select Audio Volume [708].
3. Adjust the setting according to the following table.
ZONE #2
S=6 OK
Descriptor
Signal Strength
Status
Figure 4.3: TX List Display
Signal Strength
Tones
0-2 1
Tone
3-5 2
Tones
6-8 3
Tones
8-9 4
Tones
Table 4.2: Signal Strength Tones
Summary of Contents for infinite prime
