Electronics Line infinite prime, Installation Manual

Page: 102 / 113

-102-
6. Select the zone to which you want to
register the transmitter; the system
initiates Registration mode. When
Save? appears on the control
system’s LCD display, press .
7. After registration, remove the Test
jumper and place it over one pin
for storage.
8. Before permanently mounting the
unit, test the transmitter from the
exact mounting position.
9. Attach the mounting base to the
ceiling using the screws provided.
10. Replace the cover onto its hinges
and close the cover until it snaps
together with the base.
Keyfobs (EL-2611/EL-2614/EL-2614E)
The EL-2611 and EL-2614/EL-2614E are keyfob transmitters that are supported
by the system.
Registration Procedure
To register keyfobs:
1. From the Programming menu, select Devices, Keyfobs [912].
2. Select the keyfob you want to register; the system initiates
Registration mode.
3. Press a button, making sure that the keyfob’s LED lights up when the
button is pressed.
4. Press the same button again. When Save? appears on the control
system’s LCD display, press .
EL-2611
The EL-2611 is a one-button transmitter that generates a
Medical Emergency alarm when pressed. The transmitter is
water resistant and can be worn around the neck. Its large
button makes it ideal for elderly or sight-impaired users.
When the battery is low, the EL-2611’s LED flashes during
transmission and a Low Battery signal is sent to the receiver. When
either of these two indications are observed, replace the unit.
EL-2614/EL-2614E
The EL-2614/EL-2614E is a four-button keyfob transmitter
that offers a number of functions including arm, disarm and
SOS Panic.
When the battery is low, the EL-2614/EL-2614E’s LED flashes
during transmission and a Low Battery signal is sent to the
receiver. When either of these two indications are observed,
replace the batteries.
Opening
Tab
LED
Indicator
Test
Jumper
9V
Battery
Figure B.9: EL-2603 (cover open)
Figure B.10: EL-2611
Figure B.11: EL-2614