Electrohome VistaGRAPHX 10K, User Manual

Page: 47 / 127

Downloaded from Projector.com
23(5$7,21
9LVWD
*5$3+;
#;3343 . HU * V # 0DQXDO
604<
Use the scroll bar to see and work with any additional channels not visible in the
table.
)LJXUH #60;1# &KDQQHO # /LVW # 0HQX
Beneath the Channel List window, select the "New" button, which will store the
current signal as a channel with the following defaults assigned:
•
channel number = the lowest unassigned number (up to 99).
•
switcher (SW) number = 0 (represents the projector itself). Or, if the input
source is connected to a switcher, the default will be the lowest switcher
number available (from 1-9).
•
slot (SL) = 1 ( ,QSXW 4 ), 2 ( ,QSXW 5 ), 3 ( ,QSXW 6 ), or 4 ( ,QSXW 7 ) for projector inputs, or
current slot number (1-9) if the source is connected to a switcher.
•
InMenu = checked. The source will then appear in the channel list whenever
&KDQ key is pressed.
•
AutoSource = checked. The projector will be able to automatically find this
channel on power up if the input signal matches.
•
Locked = unchecked. Settings for the channel can be changed.
If you define a new channel without a signal present, the projector memory
remains uninitialized until you "Update" the setup with an actual signal. See
Updating a Channel below.
Repeat Steps 1 and 2 for each remaining new channel you wish to add. Press
0HQX
or
([LW on the keypad to accept all new channels defined. NOTE: The new
channel will not have frequencies—use Update function.
67(3 #5
67(3 #6