Electrohome VistaGRAPHX 10K, User Manual

Page: 77 / 127

Downloaded from Projector.com
0$,17(1$1&(
9LVWD
*5$3+;
#43 . # 8VHU * V # 0DQXDO
70:
#
:$51,1*
'R # QRW # EXPS # RU # WRXFK # ODPS # OHQV # VXUIDFH 1
#
:$51,1*
5HSODFH # ZLWK # DQ # (OHFWURKRPH # ODPS # RQO\ 1# 1HYHU # WU\ # WR
RSHUDWH # WKH # SURMHFWRU # ZLWK # DQ\ # RWKHU # W\SH # RI # ODPS 1
5HSODFH # WKH # ODPS # EUDFNHW
Set the lamp bracket into the slots on the
side of the lamp compartment, making sure
both ends seat securely at the bottom of the
slots. Hand tighten the 2 knobs firmly so
that the lamp is secured as far back into the
projector as possible. See Figure 4-7.
$OLJQ # WKH # ODPS
,03257$17
: Align as per the instructions supplied with your Vista
GRAPHX
10K
Lamp Assembly and Filter Replacement Kit.
$/,*10(17 # ,6 # 0$1'$725< #
for this
projector, and must be performed whenever the lamp module is replaced or
moved.
5HSODFH # WKH # ODPS # GRRU
See Figure 4-8. Insert the top
edge of the lamp door under the
projector top lid. Swing the lid
down into place and release the
bottom spring fasteners. Slide
the fasteners firmly away from
each other to lock into the
projector handle. Secure top
latch.
5HSODFH # VLGH # ILOWHUV
Replace the 2 side filters whenever the lamp is replaced (or more frequently if
the operating environment is outdoors or is very dusty). These filters lie along
the right side panel of the projector, running from the front edge to about 9
inches from the rear.
67(3 #;
ö
)LJXUH #70:1# 5HSODFH # EUDFNHW
67(3 #<
ö
67(3 #43
ö
)LJXUH #70;1# 5HSODFH # 'RRU
67(3 #44
ö