Electia CTC-909B, User Manual

Page: 8 / 49

4
2.Configuring Your
System
<
<
I
I
M
M
P
P
O
O
R
R
T
T
A
A
N
N
T
T
N
N
O
O
T
T
E
E
>
>

While entering any PIN codes, if
incorrect codes have been input for 4
times; or over 20 numeric numbers
have been entered, it will inhibit
further key presses for 1 minute.
I. Entering Programming mode
If the system is in Alarm off mode, to enter the
Programming mode, follow the steps below.
Step 1. Press and hold # key for 2 seconds.
The screen will prompt you to enter
the User1 PIN code.
P - M o d e E n t e r
P - C o d e . . . .
Step 2. Key-in your 4 digits User PIN Code
within 30 sec.

Deafult user 1 PIN code:
Factory Default: 1234
The screen will then prompt you to
enter the Master PIN code.
P - M o d e E n t e r
M - C o d e . . . .
Step 3. Key-in 1111 (default Master Code)
within 30 sec.
Step 4. Press OK
The following message is displayed
for 2 sec.
W e l c o m e t o
P r o g r a m m e n u
Step 5. Then the available selections pf the
Programming Main menu will be
displayed.
o G e n . S e t t i n g s
S p c . S e t t i n g s
R e p o r t i n g
G S M
Step 6. Move the cursor to the desired item,
and press OK to confirm the selection.
The display will show you the
individual
programming screen
accordingly.
< < N N O O T T E E > >

If a down-arrow symbol
V
appears on
the last column of the screen, it
indicates the selection list can be
downwards scrolled. If the lowest
position is reached, the down-arrow
symbol disappears.

If an up-arrow symbol
Λ
appears on
the last column of the screen, it
indicates the selection list can be
upwards scrolled. If the upper
position is reached, the up-arrow
symbol disappears.

In Programming mode, if no key is
pressed within 2 minutes, the Control
Panel
will automatically exit
Programming mode to Alarm off mode.
2.1. Gen Settings (General
Settings)
o W a l k T e s t
C o d e S e t t i n g s
M a s t e r C o d e
G e n S e t t i n g s
S M S H e a d e r
S M S k e y w o r d
D e v i c e s + / -
2.1.1 Code Settings
In Code Settings menu, the following
parameters can be programmed at your
discretion.
o P i n C o d e
D u r e s s C o d e
T e m p . c o d e
< < I I M M P P O O R R T T A A N N T T N N O O T T E E > >

For Naming the User Name, pleas
refer to section Appendix, Naming
section for more information.

if the code is not correct, a Code