8
correct PIN code or press Disarm Button of the
RC to stop the counting and return to Alarm off
mode.
Options available are Disable (exit timer
prohibited), 10 sec., 20 sec. up to 70 sec.
in 10-sec increments.
30 sec.
is set as factory default.
2.1.3.5 A. Entry Sound (Away Entry
Sound)
This is for you to decide whether the Control
Panel sounds count-down beeps and volume
of beep during the Away entry timer (see
section 2.3.3.1).
Options available are
High
(high volume of
beep),
Low
(low volume of beep) and
Off
(no beep):
H i g h
o L o w
O f f
Low
is set as factory default.
2.1.3.6 A. Exit Sound (Away Exit Sound)
This is for you to decide whether the Control
Panel sounds count-down beeps and volume
of beep during the Away exit timer (see section
2.3.3.2).
Options available are
High
(high volume of
beep),
Low
(low volume of beep) and
Off
(no beep):
Low
is set as factory default.
2.1.3.7 H. Entry Sound (Home Entry
Sound)
This is for you to decide whether the Control
Panel sounds count-down beeps and volume
of beep during the Home entry timer (see
section 2.3.3.3).
Options available are
High
(high volume of
beep),
Low
(low volume of beep) and
Off
(no beep):
Low
is set as factory default.
2.1.3.8 H. Exit Sound (Home Exit Sound)
This is for you to decide whether the Control
Panel sounds count-down beeps and volume
of beep during the Home exit timer (see
section 2.3.3.4).
Options available are
High
(high volume of
beep),
Low
(low volume of beep) and
Off
(no beep):
Low
is set as factory default.
2.1.3.9 Door Chime
This function is available only when the
attribute of Door Contact
(DC)
and/or PIR
detector
(IR)
is set as
Entry or Away Entry
.
The Control Panel sounds a Door Chime
(Ding-Dong Sound) while the DC and/or IR is
activated in Alarm off mode.
Options available are
High
(high volume of
sound),
Low
(low volume of sound) and
Off
(no sound):
H i g h
o L o w
O f f
Low
is set as factory default.
<
<
N
N
O
O
T
T
E
E
>
>
IR Camera(CTC-852) doesn
’t support the Door
Chime function.
2.1.3.10 Warning Beep
This is for you to decide whether the Control
Panel will sound a warning beep whenever a
fault condition has been detected and
displayed. The warning beep will be silenced
after the Fault message has been read by the
user. When a new fault condition is detected, it
will then again emit a warning beep every 30
sec.
Options available are
High
(high volume of
warning beep),
Low
(low volume of
warning beep) and
Off
(no beep):
H i g h
o L o w
O f f
Low
is set as factory default.