Electia CTC-909B, User Manual

Page: 41 / 49

36
3.11. Stop the Alarm and
Alarm Display
During any alarm, the Control Panel will sound
its siren and report to the Central Monitoring
Station and the display will show.
A L A R M ! A L A R M !
A L A R M ! A L A R M !
3.11.1. Stopping the Alarm
During an alarm, to stop the siren and clear
display:
Step 1. Key in your PIN code, and then press
OK .
<
<
N
N
O
O
T
T
E
E
>
>

if you press any key other than the
first digit of your PIN code, the screen
will prompt you to enter your PIN code.
Step 2. If the PIN code is correct, then the
alarm sounding will be stopped.
< < N N O O T T E E > >

During entering PIN code, if incorrect
codes have been inputed for 4 times
or over 20 incorrect words have been
entered, it will inhibit further key
presses for 1 minute.
Step 3A. If the reporting is not complete, the
screen will display:
R e p o r t i n g . . .
P l e a s e W a i t !
After the system reported completely,
the screen will show:
P r e s s
“ O K ”
t o c o n t i n u e !
Press OK to continue.
Step 3B. If the reporting is complete , the
display will show you the triggered
event directly .
Step 4. The display will show you the device
that triggered the alarm with its zone
number is displayed:
A l a r m S t a r t e d b y
0 1 ). I R H a l l w a y

If there is more than one alarm events
have been raised, the Control Panel
continues displaying the 2nd alarm
event with 02). Starting at the
beginning of the 2nd line.
Step 5. Repeat pressing further keys until all
the alarm events are displayed
thoroughly, and then press
OK.
< < N N O O T T E E > >

If the reporting has failure, the screen
will display:
S y s t e m r e a c h e d
N o n e
Press OK to continue.

If the alarm is stopped within 90 sec.
The system will send another alarm
cancel reporting to the Central
Morning Station and the screen will
show:
A l a r m s t a r t e d b y
C a n c e l
Press OK to continue.

If the alarm is stopped after 90 sec,
the display of the Step 6 will not show.
Step 6. then the display will show:
C l e a r A l a r m
D i s p l a y ? ( O K ? )
Step 7. Press OK , the display returns to Alarm
off.
< < N N O O T T E E > >

When an alarm (other than Panic
Alarm) is raised, press the
Disarm
button on the Remote Controller will
also stop the alarm (Optional).
3.11.2. Alarm Memory
If an alarm was raised without being silenced
during your absence, and the alarm reporting
has been carried out; the screen will stay on
the
Alarm warning display.